In this article we are going to look at the option to Chain Between inside of the NX selection Filters. This option can help us minimize mouse clicks when selecting multiple edges and other geometry types.
1. In this example, we are going to create another body by extruding the perimeter of the existing body.
2. Notice the different selection filters that help you pick up multiple items based on design intent.
3. For example, if we choose Single Curve, we only get one edge selected.
4. If we choose Tangent Curves, we get what we want because of the tangencies created by the Edge blends at the intersections.
5. What if we didn’t have the tangencies all the way around the perimeter? Then we would have to do multiple selections.
6. I could use Face Edges, but I would have to deselect all the inside pockets.
7. If I use Connected Curves and try to pick up model edges, it will not pick up the entire perimeter. I need to turn on Chain Between
a. To turn on Chain between, click on the More button (Blue Arrow)
b. Turn on Chain Between and click Close
c. You have to tell NX how to chain around the connected edges of the part.
i. I’m going to click on the left side of the top horizontal edge to tell NX to chain to the left starting with that edge.
ii. Then I’m going to click on the bottom of the right vertical edge to tell NX to chain to that side of the right edge
iii. This is telling NX to chain to the left around the part back to the right edge at the bottom.
d. This allows us to get our selection with 2 clicks, especially if there are not any blends or tangencies on the model.
In summary, we can turn on Chain Between under the More button on the selection toolbar to help minimize the number of mouse clicks we have when picking up a series of edges, etc. Make sure you click the proper side of the edges to infer the chain between direction.