Solid Edge ST9 Bug with MP 4 and 5

Software affected: Solid Edge ST9 Maintenance Packs 4 and 5
Fix Status: The issue is being looked into by Siemens and should be fixed shortly.

Situation: When inside an assembly ERA environment, changing the display configuration may cause Solid Edge to hang – it appears to crash and freeze up, but that is not the case. Solid Edge is hanging on that command and will complete it after a couple minutes of waiting. Do not close the program and lose your work.

There is a workaround to prevent this from happening. If you change the pathfinder from transparent to opaque, this will prevent the hang up.

Leave a Reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.